Filter and sort
Products
Special Offers
-
Vendor: IPF 3D Print Works
Caprice Pillar Gauge Pod
Regular price From $50.00 -
Vendor: IPF 3D Print Works
G8 Cubby Gauge Pod
Regular price From $60.00 -
Vendor: IPF 3D Print Works
G8 Console Switch Cubby
Regular price From $30.00 -
Vendor: IPF 3D Print Works
Caprice Fog Light Bezels
Regular price $125.00
-
Vendor: IPF 3D Print Works
SS Console Shifter Bin
Did you closeout the gap on the SS console with the SS shifter surround? Do you want more storage (60mm deep)? Then pop this storage bin in! The manual shifter bin clips into the original shifter...Regular price $45.00 -
Vendor: IPF 3D Print Works
SS Console Swap Rear Vent Cubby
If you swapped an SS console into your Caprice, you likely had to trim or remove the AC ducts that connect to the rear vents of the console. Now you can make that vent space usable!...Regular price $30.00 -
Vendor: IPF 3D Print Works
SS Console Switch Blanks
Have buttons in the SS console that you can't use? Pop them out and replace them with these snap in switch blanks that are grained similar to the SS console. Adding a HUD and need to...Regular price $30.00 -
Vendor: IPF 3D Print Works
SS Corner Vent Gauge Pod
Want a gauge pod that replaces the vent by the steering wheel while still allowing air flow? This sticks out far enough that you can even fit an N gauge. Works for SS and 14+ Caprice....Regular price $30.00 -
Vendor: IPF 3D Print Works
SS Cubby Dual Gauge Pod
Replace your rubber cubby liner with this dual gauge pod made for two 52mm (2 1/16") gauges.Regular price $115.00 -
Vendor: IPF 3D Print Works
SS Cup Holder Trim
Cracked your cup holder trim ring? Try our drop in replacement trim. It does print without the tabs so that you don't risk cracking it upon installation but a small dab of adhesive in the old...Regular price $25.00
